Product Introduction

This machine can weave warp and weft, which are both impact-resistant and tear-resistant steel mesh conveyor belt skeleton fabric of steel wire, and warp is nylon thread, and weft is impact-resistant and tear-resistant steel mesh conveyor belt skeleton fabric of steel wire.

Technical parameters

1. Reed width: 1400-2400mm.

2. Weft density range: 50-500 pieces/10cm, which can be adjusted freely through the display.

3. Diameter of weft wire: diameter ≤ 2.39mm.

4. Diameter of warp wire: diameter ≤ 3.8mm.

5. Machine speed: 20 r/min minutes (frequency conversion speed regulation).

6. Total power of the whole machine: 5.89kw.

 

Main structure:

1. Rack: steel wallboard, integral base.

2. Transmission mechanism: variable frequency motor, reducer drive.

3. Opening mechanism: pneumatic opening.

4. Weft insertion mechanism: rigid rapier weft insertion.

5, beating up mechanism: cam beating up.

6. Coiling mechanism: servo motor drive coiling

7, send-off institutions: active frequency conversion send-off.

8. Rolling mechanism: the outer surface of the machine is rolled, and the maximum diameter of the rolling net is about 900mm.

9, electrical control: the use of programmable controller control, fault, speed and output display.

This machine can weave warp and weft, which are both impact-resistant and tear-resistant steel mesh conveyor belt skeleton fabric of steel wire, and warp is nylon thread, and weft is impact-resistant and tear-resistant steel mesh conveyor belt skeleton fabric of steel wire.